open access

https://hdl.handle.net/2115/57392

Fabrication and Dielectric Properties of (Ba0.7Sr0.3)TiO3-Glass Composites

英語

2011-09

Japan Society of Applied Physics

Japanese Journal of Applied Physics

50(9)

09NF03-1-09NF03-7

Bulk and thick-film (Ba0:7Sr0:3)TiO3 (BST)–glass composites with different dielectric properties were fabricated at 1000 C from powder mixtures of a sol–gel-derived BST and a commercial glass (GP). Increasing the calcination temperature of the BST gel powder from 850 to 1000 C resulted in an increase in the sintered density of the composites with simultaneous increases in dielectric permittivity ("r) and its temperature coefficient. Similar changes were observed in composites with different GP contents. A substantial decrease in "r with a broadened "r–temperature curve for the 12% GP composite could be attributed to the inhibited densification and enhanced formation of the secondary fresnoite phase. The dielectric properties and dielectric tunability of the composites were examined in relation to their relative density (drel), crystallinity (Lapp), and relative fraction of the BST phase (fBST). Although changes in "r, its temperature dependence, and tunability were nominally correlated with the drel change of the sintered composites, the result that the drel of the composites was basically an increasing function of Lapp and fBST suggested the substantial contributions of Lapp and fBST to those changes.

学術雑誌論文

Submitted Manuscript Under Review

0021-4922

1347-4065