open access

https://hdl.handle.net/2115/75409

As-cast Austenite Grain Structure in Al Added 0.2 wt% Carbon Steel

pinning effect

2010-02-15

日本鉄鋼協会

ISIJ International

50(2)

231-238

Effects of Al addition on as-cast γ-austenite grain structure in 0.2wt%C–0.035wt%P steel with Al concentration ranging from 0.04 to 1.04 wt% were studied by means of furnace cooling and casting experiments. In the furnace cooling experiment with a cooling rate of 0.03°C/s, the as-cast γ grain structure consisted of equiaxed grains and the γ grain size was not affected by the increase in Al concentration up to 0.54 wt%. In the casting experiment of the sample with 0.04 wt% Al, on the other hand, the as-cast γ grain structure consisted of Coarse Columnar Grain (CCG), Fine Columnar Grain (FCG) and Equiaxed Grain (EG) regions, sequentially, from the mold side to the center of the ingot. The increase in Al concentration leads to increase in the fraction of FCG region at the expense of both CCG and EG regions. Even in the samples with high Al concentrations, AlN particles were rarely found and also Al segregation did not occur substantially. Instead, P segregated in interdendritic regions. The concentration of the segregated P increased from the CCG region to the FCG region. It was suggested based on a thermodynamic calculation that the segregation of P is enhanced by Al addition and the high P concentration stabilizes the high temperature phase such as liquid or δ-ferrite, depending on Al concentration at lower temperatures. This stabilized high temperature phase is considered to retard the γ grain boundary migration. Therefore, the increase of FCG region and the decreases of CCG and EG regions due to Al addition should be attributable to pinning effect of the stabilized high temperature phase.

学術雑誌論文

Version of Record

著作権は日本鉄鋼協会にある

0915-1559

1347-5460

AA10680712