|
Hokkaido University Collection of Scholarly and Academic Papers >
Graduate School of Engineering / Faculty of Engineering >
Peer-reviewed Journal Articles, etc >
Avoiding error of determining the martensite finish temperature due to thermal inertia in differential scanning calorimetry : model and experiment of Ni-Ti and Cu-Al-Ni shape memory alloys
| Title: | Avoiding error of determining the martensite finish temperature due to thermal inertia in differential scanning calorimetry : model and experiment of Ni-Ti and Cu-Al-Ni shape memory alloys |
| Authors: | Kato, Hiroyuki Browse this author →KAKEN DB | | Sasaki, Kazuaki Browse this author |
| Issue Date: | Feb-2012 |
| Publisher: | Springer Netherlands |
| Journal Title: | Journal of Materials Science |
| Volume: | 47 |
| Issue: | 3 |
| Start Page: | 1399 |
| End Page: | 1410 |
| Publisher DOI: | 10.1007/s10853-011-5919-4 |
| Abstract: | It is known that the thermal effect (thermal inertia) in differential scanning calorimetry causes significant error of measuring the martensite finish temperature (Mf) in shape memory alloy, while the start temperature (Ms) is virtually unaffected. This article shows that the error can be avoided by accounting for the thermal effect quantitatively by mathematical modeling, if the kinetics of the martensitic transformation is properly prescribed. In common with two representative shape memory alloys, Cu-Al-Ni and Ni-Ti alloys, exponential decay is appropriate for expressing the kinetics. The model analysis is extended to the two methods of extrapolation which aims at excluding the thermal effect from DSC data. One is the extrapolation of the cooling rate to zero, and the other is that of the mass of sample to zero. It is shown that both extrapolations construct a temperature between the Ms and Mf. Typically, the temperature is below the Ms by one-third of the interval between the two temperatures. |
| Type: | article |
| URI: | http://hdl.handle.net/2115/48258 |
| Appears in Collections: | 工学院・工学研究院 (Graduate School of Engineering / Faculty of Engineering) > 雑誌発表論文等 (Peer-reviewed Journal Articles, etc)
|
Submitter: 加藤 博之
|
