|
Hokkaido University Collection of Scholarly and Academic Papers >
Graduate School of Engineering / Faculty of Engineering >
Peer-reviewed Journal Articles, etc >
Fabrication and characterization of Ni0.3Zn0.7Fe2.0O4-BaTiO3 ceramic composites
This item is licensed under:Creative Commons Attribution-NoDerivatives 4.0 International
| Title: | Fabrication and characterization of Ni0.3Zn0.7Fe2.0O4-BaTiO3 ceramic composites |
| Authors: | ABE, Kazutomo Browse this author | | KITAHARA, Naoto Browse this author | | HIGUCHI, Mikio Browse this author →KAKEN DB | | TAKAHASHI, Junichi Browse this author |
| Keywords: | Ni0.3Zn0.7Fe2.0O4-BaTiO3 composite | | Solid state reaction | | Ti-doped NiZn ferrite | | Dielectric permittivity | | Electromagnetic wave absorber |
| Issue Date: | 1-Sep-2009 |
| Publisher: | Ceramic Society of Japan |
| Journal Title: | Journal of the Ceramic Society of Japan |
| Volume: | 117 |
| Issue: | 1369 |
| Start Page: | 944 |
| End Page: | 949 |
| Publisher DOI: | 10.2109/jcersj2.117.944 |
| Abstract: | The ceramic composites containing 1-25 vol% BaTiO3 in a ferrite matrix phase of Ni0.3Zn0.7Fe2O4 were fabricated by sintering at 1250°C in air. The sintered composites indicated a steep increase in dielectric permittivity in a small BaTiO3 ratio up to 5 vol%. In a limited BaTiO3 ratio of 3-15 vol%, a reaction between Ni0.3Zn0.7Fe2O4 and BaTiO3 resulted in the production of a liquid phase during sintering, which caused correspondingly the formation of secondary phases of BaFe2O4 ss and hexagonal BaTiO3 ss. These solid phase and microstructure changes, however, brought about little contribution to the increasing permittivity of the composites. Electrical property evaluations combined with compositional analysis revealed that the remarkably increasing permittivity could be predominantly attributed to the electron hopping between Fe2+ and Fe3+ in the ferrite matrix, which was caused by the incorporation of a small amount of Ti4+ into the spinel sublattice. |
| Rights: | https://creativecommons.org/licenses/by-nd/4.0/deed.ja |
| Type: | article |
| URI: | http://hdl.handle.net/2115/73138 |
| Appears in Collections: | 工学院・工学研究院 (Graduate School of Engineering / Faculty of Engineering) > 雑誌発表論文等 (Peer-reviewed Journal Articles, etc)
|
Submitter: 樋口 幹雄
|
