Hokkaido University Collection of Scholarly and Academic Papers >
Graduate School of Engineering / Faculty of Engineering >
Peer-reviewed Journal Articles, etc >
Combustion Synthesis Ironmaking: Investigation on Required Carbon Amount in Raw Material from the Viewpoint of Adiabatic Flame Temperature Calculation
This item is licensed under:Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
Title: | Combustion Synthesis Ironmaking: Investigation on Required Carbon Amount in Raw Material from the Viewpoint of Adiabatic Flame Temperature Calculation |
Authors: | Abe, Keisuke Browse this author →KAKEN DB | Kurniawan, Ade Browse this author | Sanada, Masafumi Browse this author | Nomura, Takahiro Browse this author →KAKEN DB | Akiyama, Tomohiro Browse this author →KAKEN DB |
Keywords: | combustion synthesis | ironmaking | goethite | adiabatic flame temperature | calculation |
Issue Date: | Aug-2019 |
Publisher: | Department of Chemistry, Gadjah Mada University |
Journal Title: | Indonesian journal of chemistry |
Volume: | 19 |
Issue: | 3 |
Start Page: | 696 |
End Page: | 702 |
Publisher DOI: | 10.22146/ijc.38359 |
Abstract: | Combustion synthesis (CS) is a simple and very fast method to synthesize a target material. New ironmaking method via the CS using carbon-infiltrated iron ore was proposed, and the possible conditions for the method were investigated. Adiabatic flame temperatures (Tad) of the CS reaction, maximum reachable temperatures in an adiabatic system, were calculated to estimate the sample temperature during the CS. To reach the adiabatic temperature of 1811 K, 23.9, 27.9, and 29.3 wt.%-C were required for Fe2O3, Fe3O4, and FeO, respectively. When the carbon amount is higher than the calculated one, molten iron which is separated from slag components should be obtained via the CS. |
Rights: | https://creativecommons.org/licenses/by-nc-nd/4.0/ |
Type: | article |
URI: | http://hdl.handle.net/2115/75272 |
Appears in Collections: | 工学院・工学研究院 (Graduate School of Engineering / Faculty of Engineering) > 雑誌発表論文等 (Peer-reviewed Journal Articles, etc)
|
|