Hokkaido University Collection of Scholarly and Academic Papers >
Graduate School of Engineering / Faculty of Engineering >
Peer-reviewed Journal Articles, etc >
Use of Recycled Steel Machining Chips and Aluminum Can Shreds for Synthesizing Iron Aluminide Intermetallic Alloys
Title: | Use of Recycled Steel Machining Chips and Aluminum Can Shreds for Synthesizing Iron Aluminide Intermetallic Alloys |
Authors: | Matsuura, Kiyotaka Browse this author →KAKEN DB | Watanabe, Yoshimi Browse this author | Hirashima, Yasushi Browse this author |
Keywords: | recycling | casting | combustion synthesis | SHS (Self-propagating High-temperature Synthesis) | intermetallic compound | FeAl | Fe3Al |
Issue Date: | 15-Jul-2004 |
Publisher: | Iron and Steel Institute of Japan |
Journal Title: | ISIJ International |
Volume: | 44 |
Issue: | 7 |
Start Page: | 1258 |
End Page: | 1262 |
Publisher DOI: | 10.2355/isijinternational.44.1258 |
Abstract: | Some iron aluminide intermetallic alloys based on Fe3Al or FeAl have been synthesized from recycled raw materials of steel machining chips and aluminum can shreds. The former was an industrial waste made at a bearing case maker, and it had a spiral shape and a length less than 1 mm and contained 0.87 wt% C, 0.21 wt% Si, 1.53 wt% Cr with some other minor elements. The latter, on the other hand, was made by shredding used aluminum cans, and it had a flaky shape and a edge length of 2 to 3 mm and contained 2.3 wt% Mg, 0.36 wt% Fe, 0.88 wt% Mn with some other minor elements. When compacts of the steel and aluminum mixture were heated in a crucible in an argon atmosphere, they exothermically reacted and produced iron aluminide intermetallic alloys. For comparison, similar alloys were produced from pure iron and aluminum by melting them in the same heating apparatus. The bending strength, fracture toughness, Vickers hardness and wear resistance of the alloys synthesized from the recycled raw materials were more excellent than or similar to those of the alloys produced from pure iron and aluminum. |
Rights: | 著作権は日本鉄鋼協会にある |
Type: | article |
URI: | http://hdl.handle.net/2115/75736 |
Appears in Collections: | 工学院・工学研究院 (Graduate School of Engineering / Faculty of Engineering) > 雑誌発表論文等 (Peer-reviewed Journal Articles, etc)
|
Submitter: 松浦 清隆
|