|
Hokkaido University Collection of Scholarly and Academic Papers >
Graduate School of Engineering / Faculty of Engineering >
Peer-reviewed Journal Articles, etc >
Influence of pulse frequency on synthesis of nano and submicrometer spherical particles by pulsed laser melting in liquid
This item is licensed under:Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International
| Title: | Influence of pulse frequency on synthesis of nano and submicrometer spherical particles by pulsed laser melting in liquid |
| Authors: | Sakaki, Shota Browse this author | | Ikenoue, Hiroshi Browse this author | | Tsuji, Takeshi Browse this author →KAKEN DB | | Ishikawa, Yoshie Browse this author →KAKEN DB | | Koshizaki, Naoto Browse this author →KAKEN DB |
| Keywords: | Zinc oxide | | Pulsed laser melting | | Colloids | | Nanoparticles | | Submicrometer particles |
| Issue Date: | 30-Mar-2018 |
| Publisher: | Elsevier |
| Journal Title: | Applied surface science |
| Volume: | 435 |
| Start Page: | 529 |
| End Page: | 534 |
| Publisher DOI: | 10.1016/j.apsusc.2017.10.235 |
| Abstract: | Submicrometer spherical particles (SMSPs) are reported to be fabricated by pulsed laser irradiation with a frequency of 10 or 30 Hz onto raw nanoparticles dispersed in liquid. Here, the effect of the pulse frequency on particles obtained by laser irradiation onto the suspension in a vessel, especially at higher pulse frequencies up to 800 Hz, is investigated. At 200 Hz or lower, SMSPs of similar size can be fabricated, as at 10 or 30 Hz, by the same number of pulses. This indicates that the time required for particle fabrication can be greatly reduced and production efficiency can be improved using a high-frequency laser. In contrast, at 400 Hz or above, nanospherical particles (NSPs) are formed in addition to SMSPs, and the mass fraction of SMSPs is drastically decreased. This result suggests that consecutive laser pulse irradiation induces heat accumulation in particles and suspensions, resulting in a temperature increase and partial evaporation of the particles at 400 Hz or above. From the temperature increase of the suspension, the local temperature of the liquid surrounding the particles is believed to be increased by heat dissipation from the heated particles. Calculations suggest that an increase in the local liquid temperature would cause further heating of the particles. |
| Rights: | © 2018. This manuscript version is made available under the CC-BY-NC-ND 4.0 license http://creativecommons.org/licenses/by-nc-nd/4.0/ | | http://creativecommons.org/licenses/by-nc-nd/4.0/ |
| Type: | article (author version) |
| URI: | http://hdl.handle.net/2115/77113 |
| Appears in Collections: | 工学院・工学研究院 (Graduate School of Engineering / Faculty of Engineering) > 雑誌発表論文等 (Peer-reviewed Journal Articles, etc)
|
Submitter: 榊 祥太
|
