|
Hokkaido University Collection of Scholarly and Academic Papers >
Graduate School of Engineering / Faculty of Engineering >
Peer-reviewed Journal Articles, etc >
Simple and Cost-Effective Method to Increase the Capacity of Carbon Nanotube Sheet Cathodes for Lithium-Air Batteries
| Title: | Simple and Cost-Effective Method to Increase the Capacity of Carbon Nanotube Sheet Cathodes for Lithium-Air Batteries |
| Authors: | Ushijima, Keita Browse this author | | Iwamura, Shinichiroh Browse this author →KAKEN DB | | Mukai, Shin R. Browse this author →KAKEN DB |
| Keywords: | carbon nanotube | | carbon nanofiber | | lithium-air battery | | oxygen permeability | | cathode |
| Issue Date: | 27-Jul-2020 |
| Publisher: | American Chemical Society |
| Journal Title: | ACS applied energy materials |
| Volume: | 3 |
| Issue: | 7 |
| Start Page: | 6915 |
| End Page: | 6921 |
| Publisher DOI: | 10.1021/acsaem.0c00991 |
| Abstract: | Thin sheets for the cathode of lithium-air batteries were prepared from a mixture of long carbon nanotubes and a fibrous carbon with a larger diameter. These sheets were found to have sufficient strength and high inner permeability. The discharge capacity of the sheets tended to increase with the decrease in their gas permeation resistance. The sheet with an optimized structure showed high capacity of 17.7 mAh cm(-2) at 0.1 mA cm(-2) and a moderate rate performance of 9.3 mAh cm(-2) at 0.5 mA cm(-2). Analysis of the sheets after discharging revealed that improving the permeability of the sheets through the introduction of large pores by fibrous carbon addition leads to a significant improvement in cathode performance. |
| Rights: | This document is the Accepted Manuscript version of a Published Work that appeared in final form in ACS applied energy materials, copyright c American Chemical Society after peer review and technical editing by the publisher. To access the final edited and published work see https://pubs.acs.org/doi/10.1021/acsaem.0c00991. |
| Type: | article (author version) |
| URI: | http://hdl.handle.net/2115/82289 |
| Appears in Collections: | 工学院・工学研究院 (Graduate School of Engineering / Faculty of Engineering) > 雑誌発表論文等 (Peer-reviewed Journal Articles, etc)
|
Submitter: 岩村 振一郎
|
